![]() ![]() The string post holes can now be drilled and reamed for the peghead bushings. Force should not be needed to seat the tuners completely into the peghead.ĩ. If the drilling is done properly, the tuners will have a close fit. This technique will really make a difference in the accuracy of your holes, and in the way the tuners will work.Ĩ. Place the second alignment pin in that hole so that the two outside holes are pinned, then drill the remaining hole. Place one of the steel alignment pins in that hole and drill the other outside hole. With the jig clamped onto the peghead, drill one of the outside holes. This helps prevent chip-out of the wood or the peghead finish, and allows better centering of the bit in the jig holes.ħ. ![]() If possible, always start each hole by turning the drill bit in reverse first, then go forward to drill the hole. The pins should hold the jig positioned while you clamp it to the back of the peghead. With the tip of the pins pressed into the wood, slide the jig down the pins to contact the peghead. Place the sharp pointed transfer pins through the outer holes of the jig, and position the points on the peghead where the corresponding peg hole centers are marked. Draw a pair of straight lines, tangent to those lines, that give the tuners a pleasing "look" and functional location.Ĥ. This will keep the baseplates from hanging over the edge of the peghead. Draw a line, parallel to the edge of the peghead, which is one-half the width of the baseplate, plus. Square up from the back to meet the three cross lines on each side, and connect those lines to make three lines across the back of the peghead.ģ. If you want the tuners to mount symmetrically on the neck, these lines need to be at right angles to the centerline. ![]() Draw three lines, each connecting the centers of the holes directly across the peghead from each other. Transfer these hole locations to the back of the peghead. View All WOODSTAX - Shop Tonewood by the PieceĢ.View All All Hardware + Parts by Instrument. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |